How to set Global dimensions are mandatory in JVs - NAV 2009

Comments

• Options

  mohana_cse06 Member Posts: 5,503

  2014-09-25

  You have to set them on account ex: customer
  Open Customer and go to Dimensions
  
  There you have to set Value Posting filed to Code Mandatory or Same Code as per your requirement

  
  -Mohana
  http://mohana-dynamicsnav.blogspot.in/
  https://www.facebook.com/MohanaDynamicsNav

  0
• Options

  ssingla Member Posts: 2,973

  2014-09-30

  Also check "Account Type Default dimension". You can specify dimension posting rules for table nos. i.e. Customer, Vendor, G/L Account. If a rule is set then it will be checked no matter from where you are posting.

  CA Sandeep Singla
  http://ssdynamics.co.in

  0
• Options

  pavan Member Posts: 11

  2014-09-30

  The setup is actually stored in "Default Dimension" Table where if you see "Code Mandatory" under "Value Posting" field this would mean that no entry can be posted without dimension. While "Same code" means you can specify which dimension should be always selected while posting an entry. You can access this via customer or vendor or G/L card etc > one of the below menu > Dimensions.

  0
• Options

  fisalsharaf Member Posts: 6

  2014-10-09

  Thanks for everyone who supported me and I have solved the issue.

  0